European Standard Positioning Block Sets
Part Number
Once your search is narrowed to one product,
the corresponding part number is displayed here.
- Drawing
- 3D Preview 3D preview is available after complete configuration
- Part Numbers
- Specifications
- More Information
Drawing / Product specification
■Dimensions when combined
About dismounting tap for bolt mounting hole (N)
As shown in the left figure, the positioning block can be easily removed by screwing a bolt into its tap and extracting it.
■When using
Part Number:
- In order to open the 3D preview, the part number must be fixed.
3D preview is not available, because the part number has not yet been determined.
Loading...
Part Number
|
|---|
| D-TBSFH08-20 |
| D-TBSFH08-25 |
| D-TBSFH08-32 |
| D-TBSFH08-40 |
| Part Number | Minimum order quantity | Volume Discount | D (Outer diameter) (mm) | |
|---|---|---|---|---|
| 1 | Available | Quote | 20 | |
| 1 | Available | Quote | 25 | |
| 1 | Available | Quote | 32 | |
| 1 | Available | Quote | 40 |
Loading...
Specification table
| V | E | R | L | L1 | L2 | Dismounting tap hole | Installation bolts | Part No. | |||
| N1 | N2 | d1 | d2 | Type | D | ||||||
| 10 | 5.5 | 4 | 14 | 4 | 12 | M 5 | M 6 | M4 | M 5 | D-TBSFH08 (①＋②Set) | 20 |
| 12 | 7.5 | 5 | 16 | 8 | 13 | M 6 | M 8 | M5 | M 6 | 25 | |
| 16 | 9.5 | 6 | 18 | 12 | 15 | M 8 | M10 | M6 | M 8 | 32 | |
| 20 | 11.5 | 22.5 | 10 | 17 | M10 | M12 | M8 | M10 | 40 | ||
Order Example
| Part No. | - | D | ||
| D-TBSFH08 | - | 25 | ||
Overview・Characteristics
■Features of tapered blocks sets
・The block sets are capable of offsetting the plate's thermal expansion caused in high temperature molding process for thermosetting resins, etc.,
thereby maintaining positioning accuracy.
The pin type positioning method cannot thoroughly absorb thermal expansion when it takes place in directions as shown in the figure above.
The block type will be unaffected if the groove direction is in parallel to the directions of thermal expansion as shown in the drawing above.
■Usage
・Contacting the pin and bushing when mold is closed may cause damage. Please leave a clearance of about 0.5mm on PL.
Basic information
| Brand | C-VALUE | Components | Set (Pin + Bushing) | Shape type | Block |
|---|---|---|---|---|---|
| Tapered or straight | Straight shape | Ext. dia./External tolerance | +0.015/+0.002 | Clearance of straight shape | 0.005 to 0.015 |
| Symmetry against straight/tapered section | 0.005 or less | Material | SKS3 |
- The specifications and dimensions of some parts may not be fully covered. For exact details, refer to manufacturer catalogs .
Tech Support
Metoda de plată
Plata în cont
Pre-plată
Producție la cerere
Certificate
Copyright © MISUMI Corporation Toate drepturile rezervate.