Înregistrați-vă
Confirmat
  • Material

    In the case of Set, the block and rail use the same materials.

  • Nominal Part Number
  • Block Mounting Hole Pitch (Width Direction)(mm)
  • Block Mounting Hole Pitch (Length Direction)(mm)
  • Block Mounting Hole Diameter
  • Rail Mounting Hole Pitch(mm)
  • Rail Mounting Hole Diameter
  • Block external dimension W(mm)
  • Block external dimension L(mm)
  • Mounting hole for blocks
  • Mounting Hole Dimension S(M)
  • Mounting Hole Screw Depth(mm)
  • Block dimension L1(mm)
  • Symbols for Dust Resistance
  • Type
  • CAD
  • Est. zile de expediere
    • Toate
    • În 19 zile lucrătoare

Linear guideway carriages / large carriage, carriage dimensions selectable / material selectable / recirculating ball bearing / HSR (HSR30R1SSM(GK))

Linear guideway carriages / large carriage, carriage dimensions selectable / material selectable / recirculating ball bearing / HSR HSR30R1SSM(GK)

Cod piesă:

HSR30R1SSM(GK)
Ștergeți
Cantitate:
Loading...

Lista codurilor de piese

Număr de articole
Cod piesă
HSR30R1SSM(GK)

Block Type

Material

Nominal Part Number

Block Mounting Hole Pitch (Width Direction)

(mm)

Block Mounting Hole Pitch (Length Direction)

(mm)

Block Mounting Hole Diameter

Rail Mounting Hole Pitch

(mm)

Rail Mounting Hole Diameter

Block external dimension W

(mm)

Block external dimension L

(mm)

Mounting hole for blocks

Mounting Hole Dimension S

(M)

Mounting Hole Dimension H

(ø)

Mounting Hole Screw Depth

(mm)

Block dimension L1

(mm)

Symbols for Dust Resistance

RoHS?Cantitate minimă per comandă
Standard
Stainless Steel
30
40
40
8
80
9
60
98
Tapped Hole
M8
-
10
70.4
Seal (end+side+inner)
10
1 bucăți
Preț unitar (fără TVA)(preț unitar cu TVA incluse)
Dată de expediere standard
342.62 €
( 407.72 € )
19 zile lucrătoare

Informații detaliate

Informații de bază

An individual block from the THK LM guide HSR series. Extremely useful for sudden design changes and when performing maintenance.

[Features]
· Circulates the ball row using the end plate that is assembled in the LM block when the ball rotates the rotating side with four rows that have been precision ground into the LM block and LM rail.
· The ball will not fall out even if the LM rail is removed because it is held by a holding plate. (Excludes the HSR8,10, and 12).
· Each of the rail rows has been positioned at a 45° contact angle so that the rated load will be the same for all four directions (radial direction, reverse radial direction, horizontal direction) that act on the LM block, which allows it to be used in any position, and is also stable due to incurring a preload with a good balance, and makes it possible to maintain a constant low friction coefficient, and increase rigidity in four directions. Has a low cross-section height, and the LM block has been designed with a high rigidity, which allows for highly precise and consistent linear motion.

Codul de piesă a fost confirmat